1. Locate the four hydraulic control rods near the backhoe controls. These rods operate four hydraulic cylinders that allow movement of the backhoe.
2. Check the hydraulic fluid level. If the fluid level is low, refuel it to the manufacturer’s recommended level.
3. Check the backhoe arms for any accumulation of dirt, debris or excessive wear on the moving parts. Also check the lift arm and its connection to the machine.
4. Unscrew the cylinder caps located on the end of each of the four control rods, and inspect the rod connection points for wear or abrasion of the metal. If any damage is detected, replace the part.
5. Grease each of the control points to restrict the movement of the backhoe, ensuring that the tension is evenly distributed.
6. Tighten each of the control rods by hand. To prevent accidental loosening during use, secure the rod by tightening the nuts with a wrench.
7. Restart the machine and check for smooth operation. If the backhoe is still drifting, repeat the above steps and make adjustments as necessary.